Same Day Garage Door Repair & Service Blog

Garage Door Won't Stay Up on a Cold Morning: Diagnosing Worn Torsion Springs on Older City Doors

November 16, 2026 6 min read
Torsion spring and drum assembly above a door

A door that will not stay up is one of the few garage door faults that announces itself plainly. You raise the door, let go, and it comes back down on its own, or it hangs partway and drifts. On an older city door this is often noticed first on a cold morning, after the door has sat overnight and the assembly has not moved for hours. The important thing to understand is that a door which cannot hold its own weight is not a door with a small adjustment problem. The springs are what counterbalance the door, and when they can no longer carry it, whatever else is still working is being asked to do a job it was never sized for. That is a condition to have looked at rather than worked around. This article covers what you can safely observe from outside the door with the garage empty, the causes worth considering and what separates them, and which work belongs to a technician. Same Day Garage Door Repair & Service works on residential and commercial doors throughout San Francisco, including the Mission District, Noe Valley, Bernal Heights, and Glen Park, and the company is licensed and insured.

Start with what the door does after you let go

Stand outside the door with the garage empty and run it through a full open with the opener, then watch what happens in the seconds afterward. Note three things: whether the door holds its position or begins to descend immediately, whether it descends steadily or drops in a rush, and whether it stops partway down or continues to the floor. Note also whether the door sits level in the opening when closed, and whether it sounds different at the start of the cycle than it did a few weeks ago.

A door that descends slowly and evenly under its own weight is behaving differently from one that drops. The first points toward a counterbalance that is no longer matched to the door. The second points toward something that has failed outright. Both are worth a call, and the distinction helps the technician know what to expect before arriving.

The causes worth considering, and what separates them

A door that will not stay up has more than one possible cause, and it is a mistake to assume the springs are at fault before anything else has been ruled out.

  • A broken torsion spring. A torsion spring that has broken cannot hold the door's weight. This is mechanically certain: the spring is the counterbalance, and a spring in two pieces provides none. On a two-spring door, one broken spring may leave the door able to open but unable to stay up, or able to hold at some heights and not others.
  • Springs that are worn rather than broken. A torsion spring loses tension over its service life, and a door that once held firmly can begin to drift down as the springs age. This is a gradual change, and owners often notice it as a door that used to stay up and now does not.
  • A door binding in its tracks. If the door is catching on a misaligned track, a bent roller, or a hinge that has pulled loose, the opener may force it up while the door's own travel is restricted. The door can then fail to hold position for reasons that have nothing to do with the springs.
  • An opener that is not holding the door. Some openers hold the door at the top of travel through their own mechanism. If that mechanism is failing, the door may descend after the opener stops even though the springs are sound.

The test that separates these belongs to a technician. Checking spring tension, track alignment, roller condition, and opener holding force requires the door to be moved by hand with the opener disconnected, and that is work for someone who knows what a loaded torsion system does when it is released. Do not disconnect the opener or attempt to move the door by hand yourself.

Why older city doors show this first

Older doors in dense neighborhoods tend to be heavier than their modern equivalents, and many are single-panel tilt-up or timber doors rather than sectional doors. A heavier door puts more demand on its springs, and the springs on an older door may already have been replaced once or twice. A door that has been adjusted to compensate for weakening springs can reach a point where there is no adjustment left, and the door begins to drift.

A cold morning is often when the owner first notices. The door has not moved for hours, the garage is at its coldest, and the first cycle of the day is the one where a marginal counterbalance shows itself. What you can rely on is the observation itself: the door came up and would not stay. The technician examines the springs and cables directly and determines which of the causes above applies.

What not to do while you wait for a technician

If the door will not stay up, stop using the opener to raise it and leave it in the closed position. A door that descends on its own is a hazard to anyone standing under it, and repeated cycling puts additional load on whatever is still holding. Do not prop the door open with a broom, a ladder, or a block, and do not attempt to adjust the springs, cables, or the opener's force settings. Torsion springs, cables, and the opener drive train are all technician work.

If the door is stuck open and cannot be closed, keep people and vehicles clear of the opening and call for service. Same Day Garage Door Repair & Service can be reached at (415) 992-9484 or SameDayGarageDoorOne@gmail.com, and the company offers 24/7 emergency service alongside weekday hours of 7:00 AM to 8:00 PM and weekend hours of 8:00 AM to 6:00 PM.

What the technician will check

A service visit for a door that will not stay up typically starts with the counterbalance. The technician inspects the springs and cables, confirms whether a spring has broken, and measures whether the remaining tension matches the door's weight. From there the technician checks the tracks for alignment, the rollers and hinges for wear, and the opener for holding force and travel settings. On an older building the technician also looks at how the track and header are anchored, because the repair should not proceed until the mounting is understood.

If the springs are worn rather than broken, replacement sized to the door is usually the answer. If the door is binding, the correction may be track and roller work instead. Either way, the diagnosis comes before the repair, and a door that holds its position reliably is the measure of whether the job was done correctly.

Need this looked at by a technician? Call Same Day Garage Door Repair & Service.

Call (415) 992-9484